LSPCI

0000:01:03.0 Ethernet controller davicom semi conductor ink. 21x4 dec &#8211; tulip compatible 10x100 eth. (rev.40) subsystem unknown dev. 4454:434e. flags : busmaster medium dev sel , latency 64 IRQ 9 i/o ports at at d800 [size=256] memory at ffcffc00 (32 &#8211; bit, non-prefetchable {size=256} expansion Rom at ffc-80000 [disabled size=256k] capabilities:<available only 2 root )

DMESG

0000:01:03.0 : tulip_stop_ /rx /tx () failed
pci: found irq 9 for device 000:00:1f.2
eth0: sharing irq 9 with 0000:01:03.0
pci: setting latency timer of device 0000:00:1f.2 to 64
uhci_hcd 0000:00:1f.2 intel corp. 82801aa usb new usb bus requested assigned bus no. 1 irq 9 10 base 0x0000ef80
usbstuff

linux tulip driver version 1.1.13(may 11, 2002)
pci: found irq 9 with 000:01:03.0
pci: sharing ifq 9 with 000:00:1f.2
tulip 0: eeprom default media type autosence
tulip 0: index #0 media MII (#11) described by a 21140 MII phy (1) block
tulip 0: index #1 media 10 base t (#0) described by a 21140 MII  non-MII(0) block
tulip 0: index #1 media 100 base tx (#0) described by a 21140 MII  non-MII(0) block
tulip 0: index #1 media 10 base fdx (#0) described by a 21140 MII  non-MII(0) block
tulip 0: index #1 media 100 base tx fdx (#0) described by a 21140 MII  non-MII(0) block
tulip 0: MII transiever # config 3100 status 7809 advertizing olel.
eth0: davicom dm9102/dm9102a rev.64 at 0001d800, 00:08:a1:6f:53:96. irq 9
dmfe: davicom dm9xxx net driver version 1.36.4 (2002-10-17)
mc 97 converter and gpio not ready (0xff00)
codec semaphore : semaphore is not ready [0x1][0x300]
codec  write 1  semaphore is not ready for register 0x54
usb 1-2.2: devise descriptor read / 64 error -110
0000:01:03.0 : tulip_stop_ /rx /tx () failed
eth0 setting full duplex based on MII #1 link partner capability of 41e1
usb 1-2.2: device not accepting address 6 error -110

INTERUPTS

9: 27986 xt-pic uhci_hcd : usbl, eth0

IO PORTS

d800-d8ff tulip


CHIP

Davicom
Dm9102af
03195
m681j9

sn. apu 1408000531
pn. 18-1d-p2000-b

VAR LOG MESSAGES	

	before upgrade

oct 18 16:10:40 local host kernel : eth0: davicom dm9102 at pci 0000:01:03.0, 00:08:a1:6f:53:96, irq9

	after upgrade i think before gccand openoffice upgrade

nov 25 15:43:35 same as above

nov 25 22:24:13 local host kernel: eth0: davicom dm9102/dm9102a rev 64 at 0001d800 00:08:a1:6f:53:96 irq 9

nov 25 22:24:13 local host kernel: eth0: setting full duplex based on MII #1 link partner capability of 41e1